Code-blue CB 4-S SIGNATURE WALL/POLE MOUNT ENCLOSURE Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 45
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
Code Blue
259 Hedcor Street
Holland, MI 49423 USA
800.205.7186
www.codeblue.com
GU-160-Cpage 37 of 45
CB 4 Series
Administrator Guide
23 WM-180 Pole Mount Installation Instructions
1.0 THREAD MOUNTING STRAPS THROUGH SLOTS
2.0 HOLD BRACKET TO POLE – Set the bracket at the desired height for the Public Address Speak-
ers 180°.
3.0 BAND THE BRACKET TO THE POLE AT DESIRED HEIGHT
3.1 To eliminate waste, pull band (A) from carton as needed. With ears of buckle (B) away from
operator, slide the buckle on the banding. Lace banding around the object being clamped and
again through buckle.
3.2 Bend end of band under buckle.
3.3 Slide band in banding tool nose slot. Press down on gripper with thumb and tension clamp by
turning the handle. Maximum tension has been reached when the band stops moving through
the buckle.
3.4 When maximum tension has been reached, roll tool over buckle, at same time reversing handle
carefully at approximately three-quarters turn to avoid breakage. The band that is released will
be used in the bend and therefore there is no loss of tension.
3.5 Lift cutter lever and the band will be cut to correct length.While holding the stub of the band
with your thumb, hammer at over bridge of buckle.
3.6 Complete application by hammering the buckle ears over the stub.
4.0 ATTACH ENCLOSURE TO BRACKET
4.1 Place a rubber washer (D) on each of the four studs.
4.2 Align and place the back plate of the unit over the four studs.
4.3 Place a second set of rubber washers on each of the four studs (inside the unit).
4.4 Place a steel washer (E) on each of the four studs.
4.5 Turn a nut (F) on each of the four studs.
Bird Eye View
(banding)
Banding tool sold separately on
the Parts Order Form, part #41441.
Specications subject to change without notice or obligation on the part of the manufacturer.
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Comentarios a estos manuales

Sin comentarios