Code-blue CB 4-S SIGNATURE WALL/POLE MOUNT ENCLOSURE Manual de usuario descargar pdf (Pagina 27)

Code Blue

•

259 Hedcor Street

•

Holland, MI 49423 USA

•

800.205.7186

•

www.codeblue.com

GU-160-Cpage 27 of 45

CB 4 Series

Administrator Guide

16 CB 4 Series Remote Mount Beacon/Strobe Installation

1.0 ATTACH J-BOX TO THE POLE

1.1 Thread the banding (B) through the pole bracket (A) located on the backside of the J-box

(C).

1.2 Wrap the banding around the pole. Cut the banding to desired length.

1.3 Using a screwdriver or nut driver, tighten the banding and make sure that the unit is in the

desired location.

NOTE: J-box must be positioned so weep hole faces down.

2.0 ATTACH LIGHT TO BRACKET

3.1 Using the three M4 X 8 screws enclosed (K), fasten the strobe (J) to the round portion of the

strobe bracket.

NOTE: If the beacon/strobe is mounted upside-down, a drain hole must be drilled into the

lens to prevent it from lling with water.

3.0 ATTACH LIGHT AND BRACKET TO THE J-BOX

4.1 Connect all wiring from the strobe to the wiring from the unit inside of the J-box using wire

nuts.

4.2 Attach strobe bracket to the J-box using four 6-32 X ½ screws as shown.

All wiring must be installed and connected by experienced and certied personnel to meet local and national electrical codes, and will

include a service disconnect.

A - pole-bracket

B - banding

C - J-box

D - pole-bracket mount nut (4 each)

E - pole-bracket mount screw (4 each)

F - conduit plug

H - strobe-bracket

I - 6-32 X ½ screws (4 each)

J - strobe light

K - M4 X 8 screws (3 each) (Low voltage)

K - 10-24 X ¾ screws (2 each) (High voltage)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

CB 4 Series 10
Download Information 45

Comentarios a estos manuales

Sin comentarios

Code-blue CB 4-S SIGNATURE WALL/POLE MOUNT ENCLOSURE Manual de usuario Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Comunicación Code-blue CB 4-S SIGNATURE WALL/POLE MOUNT ENCLOSURE